Status Light/Error Light on the HP LaserJet P2030/P2035 Printers
|Control-panel Error light messages on the HP LaserJet P2030/P2035 Printers|
|Light status||State of the printer||Action|
While in the Startup state, the Go, Ready, and Attention lights cycle (at the rate of 500 ms) one after another.
During the product start up, you can request special initialization sequences that reconfigure the product. When one of the sequences is requested, such as cold reset, the lights cycle as in the Initialization/Startup state.
After the cancellation process has been completed, the product returns to the Ready state.
|During the Initialization, Reconfiguration, and Job Cancel processes, pressing buttons has no effect.|
The product is ready with no job activity.
|To print a Configuration page, press and hold the Go button for 5 seconds while the device Ready light is on and no other jobs are printing.|
The product is processing or receiving data.
|To cancel the current job, press the Cancel button.|
|Manual Feed or Continuable Error|
This state can be reached in the following circumstances:
|To recover from the error and print whatever data is possible, press the Go button.|
If the recovery is successful, the product goes to the Processing Data state and completes the job.
If the recovery is unsuccessful, the product returns to the Continuable Error state.
The print-cartridge door is open.
|Close the print-cartridge door.|
The Go, Ready, and Attention lights act independently of the Toner Low state.
|Order a new print cartridge.|
The print cartridge has been removed from the product.
|Reinsert the print cartridge in the product.|
|Paper Jam||Clear the jam.|
|Paper Out||Load paper or other media.|
The loaded paper or other media is not supported.
|Load acceptable paper or other media. Press the Go button to override thecondition.|