Replacing the toner cartridge Brother DCP-7065DN

The Brother DCP-7065DN Standard toner cartridge can print approximately 1,200 pages. The High Yield toner cartridge can print approximately 2,600 pages. Actual page count will vary depending on your average type of document. When a toner cartridge is running low, the LCD shows Toner Low.
The Brother DCP-7065DN toner cartridge that comes supplied with the machine is a Starter toner cartridge that
will need to be replaced after approximately 700 pages.

Note
• It is a good idea to keep a new toner cartridge ready for use when you see the Toner Low warning.
• To ensure high quality printing, we recommend that you use only Genuine Brother Brand toner cartridges.
When you want to buy toner cartridges, please call Brother Customer Service.
• We recommend that you clean the machine when you replace the toner cartridge.
• If you change the print density setting for lighter or darker printing, the amount of toner used will change.
• Wait to unpack the toner cartridge until immediately before you put it into the machine.

Toner Low
Toner Low
If the LCD shows Toner Low, buy a new toner cartridge and have it ready before you get a Replace Toner message.

Replace Toner
When the following message appears on the LCD, you need to replace the toner cartridge:
Replace Toner
The machine will stop printing until you replace the toner cartridge. A new and unused genuine Brother toner cartridge will reset the Replace Toner mode.

Note
To force the machine to continue printing after the LCD shows Replace Toner, set the machine to Continue mode (Press Menu, press ▲ or ▼ to choose 1.General Setup and press OK, press ▲ or ▼ to choose 4.Replace Toner, and press OK, press ▲ or ▼ to choose Continue and press OK). The machine will continue printing until the LCD shows Toner Ended.

Toner Ended
Toner Ended
The machine stops printing until you replace the toner cartridge with a new one.
Replacing the toner cartridge

• 1 Make sure that the machine is turned on.
• 2 Open the front cover and leave the machine turned on for 10 minutes to cool down.
  
• 3 Take out the drum unit and toner cartridge assembly.
  
• 4 Push down the green lock lever and take the toner cartridge out of the drum unit.
  
• 5 Unpack the new toner cartridge. Hold the cartridge level with both hands and gently shake it from side to side several times to spread the toner evenly inside the cartridge.
  
• 6 Pull off the protective cover.
  
• 7 Put the new toner cartridge firmly into the drum unit until you hear it lock into place. If you put it in properly, the green
  lock lever will lift automatically.
  
• 8 Clean the primary corona wire inside the drum unit by gently sliding the green tab from left to right and right to left several
  times.
  
• 9 Put the drum unit and toner cartridge assembly back into the machine. Close the front cover.