Resetting the Ink Counter Resetting the Ink CounterWhen an ink tank is replaced, the ink counter must be reset. The low ink warning is only displayed properly if the ink counter is reset.
Message Prompting Confirmation of Ink Tank Replacement
If an ink tank is removed, the printer will output a message prompting you to confirm replacement of the ink tank at the start of the next print job.
When an ink tank has been replaced, follow the procedure below to reset the ink counter. The low ink warning is only displayed properly if the ink counter is reset.
1 Check the message, and click Yes.
Note
Mistakenly clicking No instead, will prevent the low ink warning from functioning properly. If this happens, be sure to open the driver's Properties dialog box and manually reset the ink tank counter in the Maintenance tab.
See Resetting the Ink Counter in Printer Properties dialog box
2 Select the replaced ink tank, and click OK.
The dialog box allows you to select the replaced ink tank.
When both black and color ink tanks have been replaced, select both Black and Color.
If you have not replaced the ink tank with a new one, click Cancel.
Resetting the Ink Counter in Printer Properties dialog box
1 Open the Printer Properties dialog box and click the Maintenance tab.
See Opening the Printer Properties Dialog Box Directly from the Start Menu
3 Select the newly installed ink tank, then click OK.
|
Note |
The BJ Printer Utility cannot be used with Bluetooth communication. |
1 Double-click the hard disk icon where the printer driver was installed, the Application folder, the Utilities folder, and then the Printer Setup Utility icon.
If you are using an OS other than Mac OS X v.10.3, double-click the Print Center icon.
2 Select iP90 from the Name list and click Utility or Configure.
3 Select iP90 from the Product list and click Maintenance.
4 Select Remaining Ink Level Setting from the pop-up menu.
6 Select the newly installed ink tank, then click OK.
